This is an old revision of the document!
### Comma AI Installation Guide
#### Step 1: Remove the Rearview Mirror Cover Trim
- Removal Method:
- Hondas: Strong tug to pop it off.
- Toyotas: Slide outward.
- Tip: Check YouTube for a comma installation guide specific to your car make.
—
#### Step 2: Connect Car Harness into the Camera
- Unplug the existing LKAS camera connector.
- Plug the harness connector into the LKAS camera.
- Secure the harness box:
1. Find a location for the harness box so the trim fits over it.
2. Use the adhesive sticker to attach the harness box.
—
#### Step 3: Plug the RJ45 Cable into the Harness Box
- Steps:
1. Plug the RJ45 cable into the harness box – ensure a secure connection.
2. Route the RJ45 cable across the car to the OBD-II port (usually below the steering wheel, left side). 3. Plug the RJ45 cable into comma power and connect comma power to the OBD-II port.
—
#### Step 4: Place Mount High and Centered on the Windshield
- Mounting Preparation:
1. Clean the windshield with the included alcohol wipe and let it dry.
2. Position the mount so it is fully visible from the driver's seat. * **Adhere the Mount**: 1. Remove the 3M tape's cover and press the mount firmly in the center, then along the edges. 2. Let the adhesive cure for 48 hours before attaching the comma device.
—
#### Step 5: Plug in OBD-C and Mount the Device
- Steps:
1. Plug the right-angle OBD-C cable into the harness box.
2. Clean all three lenses of the comma device with the included microfiber cloth. 3. Plug the OBD-C cable into the back of the comma device and mount it on the windshield.
—
#### Step 6: Pair Your Device with Comma Connect
- Download the comma connect app and pair your device via [connect.comma.ai](https://connect.comma.ai).
- Claim your 1 free month of comma prime.
—
#### Step 7: Reinstall the Rearview Mirror Cover Trim
- Ensure the car harness fits fully inside the trim.
- Route the OBD-C cable out from the top.