Marlon's Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Comma AI Installation Guide ======

===== Step 1: Remove the Rearview Mirror Cover Trim =====
  * **Removal Method**:
    * **Hondas**: Strong tug to pop it off.
    * **Toyotas**: Slide outward.
  * **Tip**: Check YouTube for a comma installation guide specific to your car make.

===== Step 2: Connect Car Harness into the Camera =====
  - Unplug the existing LKAS camera connector.
  - Plug the harness connector into the LKAS camera.
  - Secure the harness box:
    - Find a location for the harness box so the trim fits over it.
    - Use the adhesive sticker to attach the harness box.

===== Step 3: Plug the RJ45 Cable into the Harness Box =====
  - **Steps**:
    - Plug the RJ45 cable into the harness box – ensure a secure connection.
    - Route the RJ45 cable across the car to the OBD-II port (usually below the steering wheel, left side).
    - Plug the RJ45 cable into comma power and connect comma power to the OBD-II port.

===== Step 4: Place Mount High and Centered on the Windshield =====
  - **Mounting Preparation**:
    - Clean the windshield with the included alcohol wipe and let it dry.
    - Position the mount so it is fully visible from the driver's seat.
  - **Adhere the Mount**:
    - Remove the 3M tape's cover and press the mount firmly in the center, then along the edges.
    - Let the adhesive cure for 48 hours before attaching the comma device.

===== Step 5: Plug in OBD-C and Mount the Device =====
  - **Steps**:
    - Plug the right-angle OBD-C cable into the harness box.
    - Clean all three lenses of the comma device with the included microfiber cloth.
    - Plug the OBD-C cable into the back of the comma device and mount it on the windshield.

===== Step 6: Pair Your Device with Comma Connect =====
  - Download the comma connect app and pair your device via **[[https://connect.comma.ai|connect.comma.ai]]**.
  - Claim your 1 free month of comma prime.

===== Step 7: Reinstall the Rearview Mirror Cover Trim =====
  - Ensure the car harness fits fully inside the trim.
  - Route the OBD-C cable out from the top.